This means that the inspection rule is the unique place to maintain your inspection lot setup data. If we run SAP S/4HANA EWM and have no plans to connect another SAP EWM system to this S/4HANA installation, then we opt for the inspection lot setup to originate from the inspection rule. If we have De-central EWM connected to S4 HANA & S4HANA Embedded EWM and if we want to use the same inspection type settings for a given material in both the EWM instances. It is recommended to maintain the orgin as “From Material Master” SAP’s recommendation for this field value is: When an Inspection lot is created,highlighted values in screen shot-3 are considered from Inspection rule and the values maintained in quality of material master become redundant.If is choosen as ” I From Inspection Rule” If we miss to define this, then when we try to post GR in EWM for a non-Quality inspected material, system throws an error “Insp.lot setup from matl master at least one active le reqd & Message no. We need to additionally define a generic inspection rule.Also in the display of inspection lot data tab “Data for Lot Origin” this is reflected as shown below.When an Inspection lot is created,highlighted values in screen shot-3 are considered from Inspection type set up in Material master quality Management view.If is choosen as ” From Material Master” Note: Above fields under “Arguments – Inspection Type Detailed Data” are only shown when the origin in respective Warehouse is choose as “I -From Inspection rule”Įffect of choosing a value in this Setting: from Inspection rule maintained using (/SCWM/QRSETUP).Material Master Quality view inspection type definition.This field decides the Inspection setup origin is either taken from Thought of sharing my understanding on the config field value “Inspection Setup Origin” defined under SCM Extended Warehouse Management-> Extended Warehouse Management -> Cross-Process Settings-> Quality Management ->Basics->Warehouse-Dependent Activation of Inspection Object Type
0 kommentar(er)
